FUSION
THE CRITICAL HYGIENE COLLECTION
FUS-01
FUS-02
FUS-03
FUS-04
FUS-05
FUS-06
FUS-07
FUS-08
FUS-09
FUS-10
FUS-11
FUS-12
FUSION
The Standard for Spaces That Can't Compromise
Fusion holds Harrington’s top wear classification, specified for critical hygiene environments where consistency isn’t optional.
FUS-01
Winter Ash
FUS-02
Mocha Veil
FUS-03
Burnt Citrus
FUS-04
Olive Forest
FUS-05
Cobalt Flux
FUS-06
Steel Stone
FUS-07
Mineral Grey
FUS-08
Blush Pebble
FUS-09
Stone Fossil
FUS-10
Deep Indigo
FUS-11
Pistachio Dust
FUS-12
Golden Ember
| Description | Fusion |
| Type of Floor Covering | Homogeneous Non-Directional Vinyl |
| Size | 2mtr*20mtr (40 m2) |
| Total Thickness | 2 mm |
| Wear Layer | 2 |
| Surface Treatment | RQ Protect : No Wax No Polish For Life |
| Total Weight | 3200 gsm |
| Installation System | As per Standard |
| Classification | Class 34 : Very Heavy Commercial Class 43: Heavy Light Industrial |
Tips for Maintenance
1. Dry-Mop Daily:-
- Removes loose grit before it gets ground into the surface underfoot: grit is the leading cause of surface scratching, and it’s the one habit that prevents the most damage for the least effort.
-
- The range is built wax- and polish-free with a PU-reinforced surface: applying a topical coating isn’t needed, and can actually dull the finish or reduce slip resistance rather than improve it.
-
- Remove any spills especially in food-and-beverage, lab or clinical areas — the longer a spill sits, the more chance of staining or of it drying into a slip hazard
-
- Use disinfectants approved for resilient flooring- strong solvents can attack and degrade the PVC over time.
-
- Leave disinfectant wet on the surface for its full stated contact time — wiping it off early means it hasn’t worked.
-
- ICUs, OTs and diagnostic areas typically need scheduled disinfection multiple times a day; general corridors and offices need far less.
-
- Most contamination — grit, moisture, oils — is walked in from outside; a few metres of matting at every external door does more to prevent contamination than any cleaning routine can undo afterward.
- Heat-welded seams close every joint into one continuous surface, so there are no grout lines or gaps for contamination to collect in — but that protection only holds if the weld stays intact, so seams need periodic inspection for lifting or separation
Request A Call Now From Our Expert
FAQs
Homogeneous vinyl is a resilient flooring where colour and composition run through the entire thickness of the sheet, rather than being printed or layered on top, so the surface stays consistent even as it wears.
It’s installed as a fully bonded system: the subfloor is prepared and primed, a self-levelling screed is applied where needed, the sheet or tile is bonded down with adhesive, then rolled to remove trapped air. Seams are closed last, by hot-air welding.